A new leather shoe is not finished the day it leaves the box. The upper has to soften at the flex point, the heel has to settle, and your feet have to learn the shape. Done patiently, breaking in turns a stiff pair into one that feels made for you. Rushed, it costs blisters and, sometimes, the shoe itself.
High-tops and chukkas add a detail that low shoes do not have: a collar that rises to or above the ankle. That means more leather in contact with the foot, more lacing to manage, and one more place where rubbing can start. This guide covers how to approach the first weeks, what is normal, and what is a sign the size is wrong.
Confirm the fit before you break anything in
Breaking in improves comfort; it does not correct a wrong size. Clarks puts it plainly: shoes that are too tight or too loose will never fit comfortably, no matter how much you break them in. Check the essentials on day one, indoors:
- Length. Leather softens and gives across the width, but as Red Wing's Berlin store notes, the length does not change as a shoe breaks in. NHS podiatry guidance from Oxford Health suggests about 1 cm between the end of your longest toe and the end of the shoe.
- Both feet. Most people's feet are slightly different sizes, so try both shoes and fit to the larger foot.
- Heel. The back of the shoe should hold the heel firmly. A small amount of lift in a stiff new shoe can settle as the sole begins to bend; a heel that slides freely, even when laced securely, is a fit question to take seriously.
- Width. Snug along the sides is acceptable in new leather; Red Wing's Berlin store describes the sides as where most of the stretching occurs. Toes pressed against each other or against the end are not.
If you are unsure of your measurements, our guide to measuring your feet for high-tops walks through two at-home methods. Do these checks on a clean indoor floor. As the Oxford Health guidance notes, shops will usually take shoes back only if they have not been worn outside.
Start indoors, in short sessions
Every credible source agrees on the first rule: short wear, often, before long wear. Clarks recommends starting with 20-minute sessions around the house and increasing the time as the shoes become comfortable. Wirecutter's experts suggest about 30 minutes at a time, repeated, until the shoe softens. Red Wing advises against going straight into all-day wear and suggests building from a few hours indoors to a short walk.
A practical progression looks like this:
- First few days: 20 to 30 minutes at a time at home, once or twice a day.
- Once those feel easy: an hour or two, including a short errand or a desk-bound morning.
- After a week or so of comfortable short wear: a half day, with a familiar pair available to change into.
- Only then: a full day, a long walk or an evening where changing shoes is not an option.
There is no fixed timetable. Clarks estimates that new shoes typically take three to four weeks to feel comfortable, with leather often taking longer than canvas. How often you wear the pair matters as much as the calendar.
Socks do more work than you think
Clarks and Red Wing both recommend thicker, cushioned socks during the break-in period. Padding reduces friction against stiff leather and spreads pressure while the upper softens. Choose socks that sit smoothly without wrinkles, and that reach above the collar of a high-top so the leather edge never rests directly on bare skin. Clarks specifically advises against going sock-free while breaking in.
Lace for control, not for room
It is tempting to leave the laces loose so a stiff shoe feels roomier. Clarks advises the opposite: lace securely. A foot that is held in place moves less inside the shoe, and movement is what turns pressure into friction. On a high-top, lace evenly through to the top eyelets so the collar supports the ankle rather than flapping against it. Our high-top lacing guide explains what each lacing method changes, including how much the collar closes.
Secure does not mean tight. If the top of the foot goes numb, or the tongue presses into the instep, ease the laces across that section.
Find hot spots before they become blisters
During those first indoor sessions, pay attention to where the shoe rubs or pulls. Wirecutter calls these hot spots. Common ones are the back of the heel, the sides of the toes and, in a high-top or chukka, the point where the collar meets the ankle bone.
Protect a hot spot as soon as you feel it, not after it blisters. Moleskin, blister pads or adhesive bandages are the usual tools; Clarks also mentions petroleum jelly on areas prone to rubbing. Then shorten the session. A shoe that rubs in the same place day after day, without improving, is telling you something about the fit.
The footwear glossary defines the parts mentioned here, from the collar and quarter to the heel counter, which helps when describing a problem to a cobbler or a brand.
Rest the pair between wears
Red Wing recommends giving leather footwear at least a full day off after a few days of consecutive wear, so the leather can dry out completely. Clarks suggests alternating new shoes with a comfortable pair so your feet can recover too. Both points support the same habit: rotate.
When the pair is off your feet, let it dry naturally at room temperature, loosen the laces and keep the shape supported. Our guide to storing high-tops and chukka boots covers that routine step by step.
What to avoid
- Long first outings. A wedding, a travel day or a long walk is the wrong place to discover a hot spot.
- Heat. Clarks warns that excessive heat used to stretch shoes can weaken adhesives and materials. Radiators, heated vents and hair dryers are not shortcuts.
- Soaking. None of the manufacturer guidance cited here recommends wetting leather to force it into shape.
- Treatments chosen by appearance. Some makers suggest a leather conditioner to soften stiff leather, but finishes differ. Use a conditioner, stretch spray or protector only when the care instructions for that exact pair allow it. Our Care Guide explains why.
- Over-stretching. A cobbler can stretch a specific tight spot. Stretching a shoe beyond its design changes its shape for good.
Normal discomfort versus the wrong pair
According to Clarks, mild stiffness, rubbing or pressure during the first few wears is normal, especially in leather. Persistent pain, numbness or significant pinching is not. A useful rule of thumb:
- Likely to settle: a stiff flex point at the ball of the foot, a slight heel lift that lessens each week, snugness across the sides.
- Unlikely to settle: toes touching the end, pain that worsens rather than eases, numbness or tingling, a heel that slides freely even when laced securely.
If discomfort continues after several weeks of gradual wear, the size or shape is the problem, not your patience. Consider a cobbler for a single tight spot, or a different size or width. If you have diabetes or reduced feeling in your feet, check with a podiatrist first; the Oxford Health guidance also recommends asking a podiatrist whenever you are unsure new shoes are suitable.
High-tops and chukkas: what is different
Both silhouettes rise to or above the ankle, so the collar is where they differ most from a low shoe. A tall high-top collar wraps the ankle and is laced closed; a chukka typically sits around the ankle with fewer eyelets and a softer opening. Our comparison of high-tops and chukka boots covers the shapes in detail. For break-in, that means:
- Check the ankle bone for rubbing at the top of the collar, especially on the inside of the foot.
- Wear socks tall enough to cover the collar line.
- Give the collar the same short-session approach as the rest of the shoe. It softens with wear too.
Hems matter here as well. A trouser or jean that bunches at the collar can press and rub. Our guide to wearing chukka boots with jeans covers cuffs and hems that sit cleanly.
Where Bertonetti fits

Bertonetti's first collection is built around exactly these silhouettes: the Signature High-Top and the Ankle Shoe, designed in NYC. The Signature High-Top designs explore a gator-embossed leather upper; the pattern is embossed into leather, not alligator skin. These pages show approved concept imagery rather than finished samples, and final specifications, care instructions and fit guidance are still being confirmed, so check Size & Fit and the Care Guide for updates. Paid ordering is not open. Join the free first-release list to be notified when it does.
Sources
- Clarks, "How to Break in Shoes: Tips for Stretching New Boots & Sneakers" (updated October 23, 2026).
- Oxford Health NHS Foundation Trust, Podiatry, "Footwear advice" (2024).
- Red Wing Heritage Europe, "Break-In Tips for Red Wing Boots."
- Red Wing Shoe Store Berlin, "FAQ."
- Wirecutter (The New York Times), "How to Properly Break In Shoes."